Quick Overview Underbody car’s protection on bitumen base. Best maintenance of your car. Perfect chassis protection of your vehicle. Easy to use. DIY.
Suitable for metal, steel, concrete devices, as well as constructions on and under the ground.

Notice:
It can be applied on raw surfaces and also when primed, and painted previously!
Do not apply top coat on preserved surface!

Stops corrosion process: Anti-rust
Sound absorbing properties – protects against stone hits
Waterproof
Chassis protection
Perfect stone protection
Protects against adverse factors (water, salt, etc.)
Short drying time up to 10 minutes !
Touch dry: 25 min; Hardened: 6 h
Efficiency 3 m² depending on type of surface by one application
Heat resistance up to 80°C
Capacity 500 ml
Colour: black

Usage:
Before applying read carefully instructions on the container and use according to the manufacturer’s recommendations.

Recommended substrate conditions:
Preparing the substrate is very important action influencing the quality and life of varnish coating. Fundamental principle, which relate to all surfaces prepared to painting is to grind, degrease and dry out. After drying the primed surface should be grinded with fine-grained sandpaper (e.g. P600).

Method of use:
Do not cover already painted surface by any other paint. Apply product at temperature about 10-20°C (optimum temperature for good varnish drying). Drying time depends also on air humidity and product density. Painting should be made in well ventilated room. Prior to commencing painting, shake the container for about one minute, which will help mix the varnish by the ball found inside. Perform the test spray. Apply the varnish with few thin layers rather than one thick layer, from the distance of 25-30 centimeters. Following applying each layer, wait a few minutes. Following the completion, clean the nozzle. Put the container upside down, pressing the nozzle for the period of three seconds.